Application repllog.exe encountered

All Application repllog.exe encountered for Windows CE 3. 0 is installed on the machine.

0 Add-On pack is installed on the machine. The current user has run Platform Builder 3. This QFE package is a collection of all QFEs produced through December 31, 2001 for Windows CE 3. If you have installed all 84 QFEs for Windows CE 3. 0, this installation is not necessary.

This package will install all QFEs directly to your build environment. You can remove any files from this directory at your choosing. Special note for users of Japanese Platform Builder 3. QFE 48 had two versions – one for Platform Builder 3. 0 English, the other for Platform Builder 3.

If you are using Platform Builder 3. If this message is displayed, it means that you have installed a QFE package with a later version of the installed file. This message is displayed to prevent accidental overwrite of the latest Windows CE QFE to that particular component. IP configuration broadcasts a message of type DHCPDISCOVER.

IP address, subnet mask, Gateway address, etc. DLL contains a function, Yuv2Rgb555MB, written in assembly language, to convert from YUV color values to RGB color values. The function spans two memory pages. After the page fault, the function will end up using the data from the overwritten scratch space which can cause an access violation. A crash may occur in DDCORE when shutting down an application from a script. FATFS file access time grows proportionally with each file. During this time, the system can not access these devices.

Critical Section Object so that another thread can not get the Critical Section Object. This fix is ported from BirchSP2 QFE 32. API to write to storage device. The problem is that it rewinds streams as it writes them in order to recalculate the correct data position to be written to a multiple sector cluster. This slows down the write process for large streams as it has to follow several links to get to the desired position. This was done to correct data corruption that occurred when wrong bytes were written to sectors.

FSTP 64bit instruction emulation code was bugged. VB6 to be used with i486 processors without a floating point coprocessor. This would cause FS drivers to never be reloaded. This is forward port of the fix for Windows CE 2. Upon failure, the host files are incorrectly deleted.

Basically, it looks like it returns whenever there’s a timer set, even if the timer hasn’t expired. When user alarm is set, the next wake-up time is recalculated. When it is cleared, however, it is not. When a key is pressed, the value assigned to it is stored in a 4 bytes variable.

This value alone is always between 0 and 255, so that would be fine. Pack, a memory leak occurs when inserting and removing a PCMCIA network card. Rx threads do not set their thread priorities correctly. This causes the whole system to crash. Potential crash in IE while executing a JSCRIPT routine.

Thus the associated code is not executed. This is seen most often when running under low memory conditions. This was found during the development of the Cedar Add-On Pack. MIPS processor, “branch likely” instructions can be interrupted in the delay slot.

C and B bits in a page table entry, this function is not used all the time. 32MB boundary which can occur for a file system larger than 32MB. Kernel allocates memory for the CPU to use as a cache. The cache is used to reduce the penalty associated with a page fault. If code is not in the cache when needed then a page fault occurs and the code will be paged into the cache. If the cache is full then code has to be discarded before the new code is loaded.